Light grey added - I used FS36495 instead of FS36628 as recommended by Two Bobs
Light grey added - I used FS36495 instead of FS36628 as recommended by Two Bobs
Light grey added - I used FS36495 instead of FS36628 as recommended by Two Bobs
Camo marked out ready for the grey and black
Camo marked out ready for the grey and black
Camo marked out ready for the grey and black
Intermediate grey on (FS36231)
Intermediate grey on (FS36231)
Intermediate grey on (FS36231)
And finally the black - I used Revell No.8 Anthracite which is slightly lighter than pure black
And finally the black - I used Revell No.8 Anthracite which is slightly lighter than pure black
And finally the black - I used Revell No.8 Anthracite which is slightly lighter than pure black
Due to problems with the black, I've ended up respraying the whole thing! Ho hum...
Due to problems with the black, I've ended up respraying the whole thing! Ho hum...
Due to problems with the black, I've ended up respraying the whole thing! Ho hum...
Due to problems with the black, I've ended up respraying the whole thing! Ho hum...
Latest progress - I've sprayed the wingtips, pylons and nose cone in neutral grey... Just need a coat of gloss varnish
Latest progress - I've sprayed the wingtips, pylons and nose cone in neutral grey... Just need a coat of gloss varnish
Latest progress - I've sprayed the wingtips, pylons and nose cone in neutral grey... Just need a coat of gloss varnish
Some more progress... I was away from home this week and managed to get most of the decals on. Just a few more to go..
Some more progress... I was away from home this week and managed to get most of the decals on. Just a few more to go..
Matt varnished and all masking removed... looking good!
Matt varnished and all masking removed... looking good!
Matt varnished and all masking removed... looking good!
At last...some more progress... After the problems mentioned above, I tidied up and repainted the underside and glossed top and bottom. In the process, I knocked off the nose probe (!) and replaced it with a pin. Just need to respray the radome with Neutral Gray now...
And ready for decals!
At last...some more progress... After the problems mentioned above, I tidied up and repainted the underside and glossed top and bottom. In the process, I knocked off the nose probe (!) and replaced it with a pin. Just need to respray the radome with Neutral Gray now...
And ready for decals!!
At last...some more progress... After the problems mentioned above, I tidied up and repainted the underside and glossed top and bottom. In the process, I knocked off the nose probe (!) and replaced it with a pin. Just need to respray the radome with Neutral Gray now...
And ready for decals!!
